![]() ![]() DK93 table press with DK93-KX adapter base. ![]() As with all punch dies, the cut pieces of fabric will collect in the top die (similar to how cut pieces of paper will collect in a paper hole punch) and will need to be cleaned out periodically.Placing a small cutting mat or piece of leather on the bottom die may provide a cushion for the surface to prolong the lifespan. Due to the mechanics of hole punching, the dies will wear down with continued use and will need to be replaced periodically, particularly the bottom die.Larger holes require much more pressure to cut than smaller holes.Cuts best on thicker material with compression (like vinyl) thin material may not achieve completely clean cuts.Size down according to the amount of expansion. If any of the above conditions apply, a cutting die smaller than the grommet size is recommended since the resulting hole will expand.Use the same cutting die size as the grommet if your material has no stretch/give and will not unravel/fray at the cut (ie.Our 17mm bottom die accommodates top cutting dies up to 17mm, so you can use the same bottom die for all smaller sizes. Both a top cutting die piece and a bottom piece are needed. Quickly cuts out a hole in your fabric or vinyl for easy snap, rivet, or grommet placement. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |